Sign In / Register

Introduction
W-001 module uses TI CC3200 chip, built-in a industrial grade ARM-Cortex-M4 kernel, frequency reaches 80MHz, contains a large number of peripheral interface, support 802.11b/g/n protocol, encryption engine built a powerful, low power superior performance

Characteristic
1 Built-in TCP/IP and TLS/SSL protocol stack, HTTP support server protocols
2 Support STA access point mode, AP mode and direct Wi-Fi access mode
3 The 256bit AES encryption support TSL/SSL secure connection
4 Support for individual and enterprise levels WPA2 security
5 Support smartConfig, AP and WPS2.0 configuration
6 As Client can connect 8 sockets, 2 safety socket
7 As Server can monitor 8 socket, the safety socket 2
8 External rich interface: camera, I2S, SD/MMC. UART, SPI, 4 Channels ADC
9 Low power consumption, 4uA deep sleep current, fast connecting, , from deep sleep to establish connection only need 95ms, and establish a secure connection only need 200ms
10 Wi-Fi: 802.11.4b/g/n 
11 Power supply: 2.1-3.6V
12 Module size: 30.4*17.91 mm
13 Pad clearance: 2mm
14 Working temperature: -40 – 85 degree

Application
Home automation, home appliance control, security system, only the energy, the gateway to the Internet, industrial control, only the socket, metering, wireless audio, wireless doorbell, sensor network nodes and so on

Interface characteristics
1 SPI
Support the master or slave mode
Support 3-wire or 4-wire mode
Support full duplex or half duplex
The highest communication clock 20MHz
SPI clock polarity and phase programmable
2 UART
Support 5,6,7,8 data bits
Speech by Even, odd, stick or no parity
The 1 bit or 2 bit stop bit
The maximum baud rate is 3Mbps
3 I2C
Support the master-slave manipulation
The standard rate of 100Kbps, the fastest 400kbps
Support multiple hosts
Host master arbitration and time synchronization
4 ADC
4-channel ADC, 12bit
The sampling time of each channel is 16us
Automatic cycle sampling
5 Camera interface: support a 8 bit parallel camera interface
6 GPIO
Programming output 2Ma-14Ma, step 2mA
Support open drain mode
Configuration drop-down, 10uA current