Sign In / Register

Processor Parameters

STM32F030 uses ARM Cortex kernel, speed up to 48 MHz. STM32F030 is the lowest price product in STM32 series, has a full set of peripherals, such as high speed 12 bit ADC, advanced and flexible timer, calendar and RTC communication interface (such as I2C, USART and SPI).

The combined easily surpass 8 bit architecture, let all application designers can benefit from the advanced 32 bit kernel simple and efficient. STM32F030 value type provides a variety of memory and a pin number combination, the device can match less, therefore further enhances the efficiency of the total cost of project.

Using application designer STM32F030 can upgrade any device is powerful in the STM32 series, and high reusability tool and application software.

Key Features

•Core: ARM®32-bit Cortex™-M0 CPU, frequency up to 48 MHz

•Memories

•16 to 64 Kbytes of Flash memory

•4 to 8 Kbytes of SRAM with HW parity checking

•CRC calculation unit

•Reset and power management

•Voltage range: 2.4 V to 3.6 V

•Power-on/Power down reset (POR/PDR)

•Low power modes: Sleep, Stop, Standby

•Clock management

•4 to 32 MHz crystal oscillator

•32 kHz oscillator for RTC with calibration

•Internal 8 MHz RC with x6 PLL option

•Internal 40 kHz RC oscillator

•Up to 55 fast I/Os

•All mappable on external interrupt vectors

•Up to 36 I/Os with 5 V tolerant capability

•5-channel DMA controller

•1 x 12-bit, 1.0 μs ADC (up to 16 channels)

•Conversion range: 0 to 3.6 V

•Separate analog supply from 2.4 up to 3.6 V

•Up to 10 timers

•One 16-bit 7-channel advanced-control timer for 6 channels PWM output, with deadtime generation and emergency stop

•One 16-bit timer, with up to 4 IC/OC, usable for IR control decoding

•One 16-bit timer, with 2 IC/OC, 1 OCN, deadtime generation and emergency stop

•Two 16-bit timers, each with IC/OC and OCN, deadtime generation, emergency stop and modulator gate for IR control

•One 16-bit timer with 1 IC/OC

•One 16-bit basic timer

•Independent and system watchdog timers

•SysTick timer: 24-bit downcounter

•Calendar RTC with alarm and periodic wakeup from Stop/Standby

•Communication interfaces

•Up to two I2C interfaces: one supporting Fast Mode Plus (1 Mbit/s) with 20 mA current sink

•Up to two USARTs supporting master synchronous SPI and modem control; one with auto baud rate detection

•Up to two SPIs (18 Mbit/s) with 4 to 16 programmable bit frame

•Serial wire debug (SWD)

Onboard Information
1 USB to serial port (CP2102), can download the program through the serial port
2 A key
3 A controllable LED
4 An adjustable resistor
5 All I/O are used for 2.54mm spacing double row pin interface to leads out

Shipping list
1* STM32F030 development board 
1* High speed Mini USB line