Sign In / Register

Processor Parameters

ARM Cortex-M0+ processor

 - running at frequencies of up to 30 MHz

 - Nested Vectored Interrupt Controller (NVIC)

 - System tick timer.

 - Serial Wire Debug (SWD) and JTAG boundary scan modes supported

 - Micro Trace Buffer (MTB) supported.

Memory:

 - Up to 16 kB on-chip flash (ISP and IAP via on-chip bootloader software)

 - Up to 4 kB SRAM

 - ROM API support: Boot loader, USART drivers, I2C drivers, Power profiles

Digital peripherals:

 - High-speed GPIO interface with up to 18 General-Purpose I/O (GPIO) pins

 - GPIO interrupt generation capability

 - Switch matrix for flexible configuration of each I/O pin function

 - State Configurable Timer (SCT)

 - Multiple-channel multi-rate timer (MRT)

 - Self Wake-up Timer (WKT)

 - CRC engine.

 - Windowed Watchdog timer (WWDT)

Analog peripherals:

 - Comparator with external voltage reference

Serial interfaces:

 - 3 USART interfaces

 - 2 SPI controllers

 - I2C-bus interface

Clock generation:

 - 12 MHz internal RC Oscillator (IRC)

 - Crystal Oscillator (SysOsc) with operating range of 1 MHz to 25 MHz

 - Programmable watchdog oscillator with a frequency range of 9.4 kHz to 2.3 MHz

 - 10 kHz low-power oscillator for the WKT

 - PLL allows CPU operation up to the maximum CPU rate

 - Clock output function with divider that can reflect various clocks

Power control:

 - Integrated PMU (Power Management Unit)

 - Reduced power modes: Sleep mode, Deep-sleep mode, Power-down mode, Deep power-down mode

 - Power-On Reset (POR)

 - Brownout detect

Unique device serial number for identification

Single power supply

Onboard Information
1 USB to serial port, it can download program by FlashMagic
2 RGB LED
3 A function key
4 An adjustable resistor
5 All of the I/O led to the edge of the board

Shipping list
1* LPC812 development board 
1* High speed Mini USB line